HOW WE INSTALL ON YOUR ROOF

Locating trusses to drill pilot hole

FIRST, WE LOCATE THE TRUSS AND DRILL A PILOT HOLE

IMG_0685.JPG

WE THEN PUT SILICONE INTO THE HOLE

IMG_0686.JPG

AN ELEVATED PLATFORM DIVERTS WATER AWAY, WHILE A STACK OF RUGGED COMPONENTS RAISES THE SEAL AN ENTIRE INCH

IMG_0689.JPG

 THE 7" LAG SCREW HAS SILICONE SEALS AND WHEN DRIVEN DOWN, CREATES AN EVEN STRONGER SEAL

IMG_0690.JPG

THE LAG SCREW IS DRIVEN DOWN, CREATING AN EVEN TIGHTER SEAL

IMG_0691_edited.jpg

THE CAP IS SCREWED ON PROVIDING AN EXTRA MEASURE OF WATER PROOFING

IMG_0697.JPG

THE  RACKING IS INSTALLED , USING THE SLOTTED CAPS TO TAKE OUT ANY ROOF VARIASTIONS

IMG_0698.JPG

THE SOLAREDGE POWER OPTIMIZER IS A DC/DC CONVERTER WHICH IS CONNECTED BY INSTALLERS TO EACH SOLAR MODULE TURNING THEM INTO SMART MODULES. THE SOLAREDGE POWER OPTIMIZERS INCREASE ENERGY OUTPUT FROM PV SYSTEMS BY CONSTANTLY TRACKING THE MAXIMUM POWER POINT (MPPT) OF EACH MODULE INDIVIDUALLY. FURTHERMORE, THE POWER OPTIMIZERS MONITOR THE PERFORMANCE OF EACH MODULE AND COMMUNICATE PERFORMANCE DATA TO THE SOLAREDGE MONITORING PLATFORM FOR ENHANCED, COST-EFFECTIVE MODULE-LEVEL MAINTENANCE

IMG_0700.JPG

EACH SOLAR PANEL GETS ONE OPTIMIZER

IMG_8462.jpeg

THE PANELS ARE STAGED AND READY FOR INSTALLATION

IMG_0682.JPG

THE "T" BOLT HOLDS THE PANEL IN PLACE

20200402_113025.jpg

SOLAR PANELS ARE COMPLETE. BY USING THE SLOTTED CAPS, ANY VARIATION IN THE ROOF IS MITIGATED , GIVING A CLEAN AND FLAT  LOOK

ABC14B49-C422-4A7C-8FB8-6A9C474AB526.jpe

For wire management, when possible we prefer to run the wires through the "SolaDeck" junction box.

Wheeler Meters.jpg

 

Finishing with the Inverter, Rapid Shut-down, and Production Meter